Can silk soap whiten your skin? Can silk soap remove red blood streaks?

Washing your face with silk soap has many benefits for the skin, including removing blackheads and acne. So can silk soap be used to whiten the skin? How to use silk soap?

Can silk soap whiten your skin?

One of the main functions of silk soap is whitening. While whitening, it can also hydrate and moisturize the skin. It contains brushed cocoon shells, which have a whitening effect.

How to use silk soap

For a new soap, first of all, you need to soak the entire soap in warm water for about a minute to allow the silk fibroin in the entire soap to fully contact with the water. Gently rub left and right and pat up and down, repeat this action three to four times, and a slippery essence will dissolve on the surface. At this time, gently tap the soap body and the essence will immediately return to silk. When the soap body is used for about five days, a small amount of sticky water can pull out real silk. Silk is thin and light, can float in the air and will not melt. If you apply too much water or create a lot of foam, there will be no stringing. The trick is to control the water.

Can silk soap remove red blood streaks?

1. Goat milk contains lactic acid, which can effectively remove skin dead skin, clean, soften and nourish the skin.

2. Silk protein for removing lines and wrinkles: Silk soap, as the name suggests, contains silk protein. Silk protein has a strong ability to hydrolyze and penetrate. After being applied to the skin for about 10 seconds, the silk protein can penetrate the dermis of the skin and play a moisturizing role. The silk protein in silk soap is easily absorbed by cells as nutrition and participates in cell metabolism. Simply put, silk soap can promote skin cell regeneration. Regular use of silk soap can not only remove fine lines and delay skin aging, but also make the skin radiant from the inside out.

How to make silk soap

1. Wash the silk cocoons, boil them in water, and then take them out. Dissolve the boiled water in alkali. Note that if your silk cocoons are 50g and the water volume is 351g, there must be a lot of water in the cocoons after boiling. The total of these two should be 401g. Then use the remaining water after taking out the cocoons to dissolve the alkali. This way you don't have too much water.

2 Put the cocoons into the dissolved alkaline solution little by little. Note that you must put them in little by little. If you put them all in at once, they will not dissolve. Keep doing this until all the cocoons are dissolved.

3. After that, it is the normal oil and alkali mixing and then put into the mold. The demoulding and stamping of soap requires more caution than other soaps. Although some oil is added to increase the hardness of the soap, the proportion of silkworm cocoons is high, so the soap will still be soft overall. Freshly cut soap looks a bit like cheese. As it matures, its color becomes darker and deeper.