How to make foam from facial cleanser and why to make bubbles

Facial cleanser is something that many people like to use. It can cleanse your skin. How can you make foam with facial cleanser? Why do we need to make facial cleanser into bubbles?

How to make foam with facial cleanser

1. Before using facial cleanser, wet your face and hands with clean water and keep them moist.

2. Squeeze an appropriate amount of facial cleanser into the palm of your hand. Be careful not to use too much or too little, depending on the area of ​​your face.

3. After squeezing the facial cleanser, rub your hands continuously until abundant foam appears, then apply the foam to your face, massage your face for about one minute, and rinse with clean water.

Why should facial cleanser be made into bubbles?

1. Helps to thoroughly cleanse the skin

Apply facial cleanser directly on your face. Because facial cleanser is emulsion, it is difficult to produce foam without prior kneading. If the facial cleanser does not produce sufficient foam, it will not only affect the cleansing effect and fail to completely remove skin oil and dirt, but also the ingredients in the facial cleanser may remain in the skin pores, causing acne.

2. Avoid skin irritation

The reason why facial cleansers can produce foam is that they need to be added with water. Most facial cleansers contain soap-based ingredients, which are very irritating to the skin, so we dilute them with water. However, if they are not diluted with water, no foam will be produced. If you apply them directly to your face, the irritation to the skin will be greatly increased.

People with sensitive skin are likely to experience allergic symptoms such as redness, fever, and itching.

3. Prevent facial moisture absorption

The process of facial cleanser producing foam is actually a process of absorbing moisture. If you directly apply the process of rubbing the facial cleanser to produce foam on your face, the facial cleanser will absorb the moisture on your face. In this way, your skin will feel very dry and tight after washing your face. Therefore, we need to rub foam on our hands first and then put it on our face.

This is an introduction to the methods and reasons for making bubbles with facial cleansers. There is knowledge everywhere in life.