How to use and clean Yameng 10t

Ya-Men 10t is a facial cleansing device product from Japan. It is very popular in Japan. So how to use Ya-Men 10t? How to clean Ya-Man 10t?

How to use Yameng 10t

The traditional way to wash your face is to use your hands directly, but now more and more girls choose to use a cleansing device to clean their facial skin, because the cleansing power of the cleansing device is stronger and can clean the skin better.

The first step is to remove makeup and cleanse your face. Before using yaman10t, remove makeup and cleanse your face with a facial cleanser. The deep cleansing function of yaman10t is achieved in conjunction with toner, just like the secondary cleansing we usually do with toner, so be sure to wash your face before that.

Step 2, cleaning mode (export). Fix the cotton pad on the beauty instrument, then drop cleansing lotion onto the cotton pad to soak it. Press the switch of the beauty instrument, the first mode is cleaning mode, then press the level button on it to adjust the intensity. It starts with the RF preheating mode, and after half a minute it changes to cleaning + vibration, with a prompt sound in between. One cleaning mode will have 6 cycles.

The third step is moisturizing mode (import). Remove the previous cotton pad, wipe the electrode tip clean with a dry towel, replace it with a new cotton pad, and drop moisturizing lotion on the cotton pad to soak it. Switch modes and adjust the intensity. It also starts with the RF preheating mode, and changes to introduction + vibration after half a minute. There is a prompt sound in the middle, and the moisturizing mode also has 6 cycles. The moisturizing mode can also be used when applying a facial mask.

Step 4: EMS mode. If the previous step was used with a facial mask, then this step can be used with the remaining mask essence. Generally, after applying essence on the face, switch the mode, adjust the intensity, and then massage the entire face. There will be a sense of electric current stimulation during use, so pay attention to adjust the intensity to suit yourself.

Step 5: LED red light mode. No need to apply any skin care products, just turn on the red light and apply it on the skin avoiding the skin around the eyes. The eye area needs to be used at a distance of more than 5cm when the eyes are closed.

Step 6: Cooling mode. No need to apply any skin care products, just switch modes, adjust the intensity, and use it repeatedly on your face in the order of press - leave - move. Do not stay in the same area for too long to prevent low-temperature burns.

Step 7: Finishing. After the treatment, you can tidy up your face a little and apply some lotion or cream. Remove the cotton pad and wipe off the lotion and gel stuck on the electrode tip and the cotton pad fixing ring. Do not wash with water.

How to clean Yameng 10t

1. Take a coin-sized amount of baby bath gel and place it in the palm of your hand.

2. Wet the cleansing brush head with warm water

3. The palms of the hands with baby bath gel are dimpled

4. Start the facial cleanser and set it to the lowest vibration setting.

5. Aim the brush head of the facial cleanser at the palm of your hand with shower gel.

6. Clean for 3 minutes

7. Use clean water to clean the foam on the cleansing instrument.

8. Place the cleansing device in a dry and ventilated place to dry.

Okay, my friends, you all understand it clearly and know how to use Yameng 10t.